4) Heat Detectors – “Perform heat test with a listed and labelled heat source or in accordance with the manufacturer’s published instructions.”

7a) Smoke Detectors – functional test – “Test smoke detectors in place to ensure smoke entry into the sensing chamber and an alarm response. Use smoke or a listed and labeled product acceptable to the manufacturer or in accordance with their published instructions. Other methods listed in the manufacturer’s published instructions that ensure smoke entry from the protected area, through the vents, into the sensing chamber can be used.”

7d) Smoke Detectors – Air sampling- “Test with smoke or a listed and labeled product acceptable to the manufacturer or in accordance with their published instructions. In the absence of an automatic, listed airflow supervision feature, test from the end sampling port on each pipe run and verify airflow through all other ports or points.”

12) Multi-sensor fire detector or multicriteria fire detector or combination fire detector- “Test each detector in accordance with the manufacturer’s published instructions. Test each of the sensors present within the detector (e.g., smoke/heat/CO. etc) independently for the specific detection principle, regardless of the configuration status at the time of testing, or individual sensors together if the technology allows individual sensor responses to be verified, or where sensors cannot be tested individually, test the primary sensor.”